September 29, 2016 § Leave a comment
Just when I was getting worried that the growing armada of boats in my garage would prevent me from building another kayak over the winter, my newest build (see pics here) found a new home. Of course, it had to happen the day before I was to take it along on a camping trip, but what can you do?
Now that it’s cooler, a man’s mind turns to thoughts of stripping. But before that can happen, he must make the necessary preparations.
And so I mounted the forms on my trusty strongback, made sure everything was aligned properly, and it was off to the races.
This build features a sheer clamp as shown below.
The sheer clamp is made out of a 3/4″ x 7/8″ length of cedar which is rounded on the inside edge.
The instructions suggest using finishing nails to fasten the sheer to the forms, but I find that drywall screws keep everything nice and tight against the form. Just be careful that you don’t drive in the screw too much as this will crack the sheer. And yes, I am speaking from experience.
Next, I set about fashioning the internal stems. For these, I used discarded lengths of cedar strips. I floated them in the bathtub for a day to make them more bendable. Even then, the stern caused me a little trouble with the outside strip cracking a little because of the pronounced curve of the stern mold. Next time, I’ll plane these strips a little thinner, as I normally do for the outside stems, to make them complain less at being bent.
For the inner stems, I used Gorilla Glue between the strips, which has never failed me before. The glue leaves a crusty foam, but this is easily removed.
Next steps: shaping the stems and preparing strips.
It’s good to be building again.